You are here: HOME > INFORMATION & RESOURCES > CREMATION and MEMORIAL JEWELLERY FILLING

Cremation and Memorial Jewellery Filling Instructions

IMPORTANT NOTE: It is understandable that some people don't feel comfortable filling their cremation jewellery themselves. If you feel at all uncomfortable about this process you may like to know that many of our customer have taken their jewellery to their local funeral home for filling. Everything the funeral director will need (funnel, instructions etc) is supplied with your order. We recommend that you phone your local funeral director ahead to discuss this option with them should you wish to have it filled this way.

We recommend that you read these instructions in full before commencing.

Pendants with a screw opening require extra care when opening and closing to ensure the screwdriver does not slip and scratch the surface.

• Remove pendant from chain and unscrew the opening either by hand (for screw top bail), or with the small screwdriver provided (for screw openings). If you have a screw top bail which is tightly shut use a toothpick (or opened paperclip etc) through the top fixed ‘loop’ as a lever to open it. Simply feed it through the fixed loop, grasp at the middle (close to the pendant) and gently twist.

• Place the end of the funnel provided into the opening. Carefully spoon a small amount of only the finest ashes into the funnel. You may need to stir the ashes around in the funnel with a toothpick to allow them to go through. The pendant should only be filled to about 90% of capacity. (If the opening of your pendant is particularly small, it can sometimes be easier to use a folded piece of paper to ‘slide’ the ashes into the pendant. Simply fold a piece of paper and open it up again. Place some of the finest ashes along the crease of the paper and point the outside edge of the crease into the opening. When tilted the ashes will slide along the crease and into the pendant.)

• After filling, clean the opening with a cotton-bud or toothpick. At this stage if you replace the screw, or twist the top bail back on, your pendant will be safely secured and WATER RESISTANT, however you may wish to permanently seal/waterproof your pendant. No memorial jewellery is entirely waterproof without this step.

• PERMANENT SEALING/WATERPROOFING

If you wish to have your pendant withstand short periods of contact with water you can use an adhesive to seal the opening. All memorial jewellery requires this step to then be water tight. (Note: Gold Vermeil jewellery should be kept as dry as possible and never immersed in liquids of any kind).

To waterproof the pendant we recommend using a small amount of clear two part metal adhesive. Most hardware stores will have this. It is best to use an adhesive which takes a few minutes to set as you may need to adjust the alignment. (We do not recommend using superglue as it dries too quickly.) Please ensure that the threads are as clean as possible to ensure good adhesion. Using a toothpick or similar, apply a very small amount to either the threads or the inside of the threaded opening and carefully screw shut. Be sure that none of the adhesive spills on to the pendant - if it does you can try to remove it by quickly wiping it with a soft lint-free cloth.

Allow at least 24 hours for your pendant to completely set. NOTE: Even when sealed your pendant should never be fully immersed in water for long periods of time. To ensure a 100% waterproof seal speak to a jeweller about soldering your pendant shut.

IMPORTANT: Be sure to keep some ashes in case your pendant is ever lost or stolen.

FULL AND MORE DETAILED INSTRUCTIONS ARE SUPPLIED WITH EVERY ORDER.